AbstractsEngineering

The primary objectives of this research were to understand the potential for gravity-stable surfactant floods for enhanced oil recovery without the need for mobility control agents and to optimize the performance of such floods. Surfactants are added to injected water to mobilize the residual oil and increase the oil production. Surfactants reduce the interfacial tension (IFT) between oil and water. This reduction in IFT reduces the capillary pressure and thus the residual oil saturation, which then results in an increase in the water relative permeability. The mobility of the surfactant solution is then greater than the mobility of the oil bank it is displacing. This unfavorable mobility ratio can lead to hydrodynamic instabilities (fingering). The presence of these instabilities results in low reservoir sweep efficiency. Fingering can be prevented by increasing the viscosity of the surfactant solution or by using gravity to stabilize the displacement below a critical velocity. The former can be accomplished by using mobility control agents such as polymer or foam. The latter is called gravity-stable surfactant flooding, which is the subject of this study. Gravity-stable surfactant flooding is an attractive alternative to surfactant polymer flooding under certain favorable reservoir conditions. However, a gravity-stable flood requires a low velocity less than the critical velocity. Classical stability theory predicts the critical velocity needed to stabilize a miscible flood by gravity forces. This theory was tested for surfactant floods with ultralow interfacial tension and found to over-estimate the critical velocity compared to both laboratory displacement experiments and fine-grid simulations. Predictions using classical stability theory for miscible floods were not accurate because this theory did not take into account the specific physics of surfactant flooding. Stability criteria for gravity-stable surfactant flooding were developed and validated by comparison with both experiments and fine-grid numerical simulations. The effects of vertical permeability, oil viscosity and heterogeneity were investigated. Reasonable values of critical velocity require a high vertical permeability without any continuous barriers to vertical flow in the reservoir. This capability to predict when and under what reservoir conditions a gravity-stable surfactant flood can be performed at a reasonable velocity is highly significant. Numerical simulations were also used to show how gravity-stable surfactant flooding can be optimized to increase critical velocity, which shortens the project life and improves the economics of the process. The critical velocity for a stable surfactant flood is a function of the microemulsion viscosity and it turns out there is an optimum value that can be used to significantly increase the velocity and maintain stability. For example, the salinity gradient can be optimized to gradually decrease the microemulsion viscosity. Another alternative is to inject a polymer drive following the surfactant…