AbstractsChemistry

Over the past two decades, organic semiconductors played a growing part as active layers in several electronic systems such as sensors, field‑effect transistors or light emitting diodes to cite a few. In fact, organic materials offer a high versatility and flexibility. However, pure organic systems often lack stability and robustness, which can be overcome by combining them with inorganic scaffolds. In this work, a conducting polymer, polypyrrole (PPy) is employed to create new sensor elements based on the combination of both inorganic and organic layers. Electrical measurements, infrared spectroscopy and current sensing atomic force microscopy provides a better understanding of the polymer behavior upon immersion in aqueous solutions. The observed discharge in water leads to a straightforward application of the device as an in‑flow sensor for several acids like HCl, H2SO4 and H3PO4. The wide range of sensing concentrations as well as the low detection limit place the present detector among the best reported so far in the literature. In a further step to turn towards lab‑in‑a‑tube devices, tubular‑shaped‑integrated microelectrodes are developed by using the rolled‑up technology. As a proof of concept, the successful integration of PPy as an active layer and its use as a gas sensor for volatile organic compounds (VOCs) is demonstrated. Finally, by adapting the rolled‑up top electrodes, as developed by Bof Bufon et al. for self‑assembled monolayers (SAMs), thin PPy films (<50 nm) are vertically contacted and their electrical characteristics measured as a function of temperature and electric field. From the transport investigations, it is observed that an insulating‑to‑metallic transition occurs in the polymeric film by increasing the bias voltage. Other molecular layers like CuPc can be incorporated in these platforms, opening the way towards emerging organic devices.